Tel: (+44) 01224 249414 | Fax: (+44) 01224 248948 | Email: This e-mail address is being protected from spam bots, you need JavaScript enabled to view it

Products

Non-Metallic Gaskets and Gasket Sheeting

These gasket materials are used for low pressure classes 150lb and 300lb. All the materials described in this section can be supplied in sheeting form or as Cut Joints to meet flange standards or customer-specific dimensions. These materials can be obtained in various thicknesses from 0.50mm to 3.00mm for all materials types listed below. The Rubber materials can be supplied up to 6.00mm thick.

Huge Range of Gaskets Available

CNAF Soft Cut Joints, CNAF Sheeting, Neoprene Rubber, Nitrile Rubber, EPDM Rubber, Buytl Rubber, Soft Cut Joints, Tanged Graphite, Nickel Reinforced Graphite, High Temperature Sheeting, High Temperature Soft Cut Joints

Scope of Gaskets We Supply

The following Non-Metallic materials fall whitin our scope of supply:

Elastomers - Neoprene, Nitrile, Buytl & Viton Rubber products.
Compressed Non Asbestos Fibre (CNAF) - Alba Gaskets will only supply materials that conform to specification BS 7531. There are two grades that fall into this category; Grade Y and Grade X.
Graphite Laminates - There are two main material types that fall within this range of products; Tanged Graphite and Nickel Reinforced Graphite.
PTFE Materials - There are two main material types that fall into this category; Virgin PTFE and Biaxially Modified PTFE or better known as Blue PTFE.

Alba Gaskets,
Block 1, Unit 10,
Souterhead Industrial Centre,
Altens, Aberdeen AB12 3LF

Site Map

Tel:01224 249414
Fax:01224 248948
Email: This e-mail address is being protected from spam bots, you need JavaScript enabled to view it

FPAL Registered - 10050983